AlexMos 32 BIT BGC with GM2804H-100T Encoder  System Combo Set

AlexMos 32 BIT BGC with GM2804H-100T Encoder System Combo Set

$299.99
Product Code: G006438
Check out with PayPal


Product Description

Encoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency.

What's encoder technology in brushless gimbal control system?

The 3 axis stabilization gimbal system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization relies on the principles of inertia (the tendency of an object to resist change in its motion) and requires that the camera is well-balanced in the Pan, Tilt, and Roll Axes. Active stabilization refers to the techniques of using sensors to measure the camera’s Pan, Tilt, and Roll movements and counteract those movements using motors attached to the 3 axes. 

Features:

- Easy to do gimbal tuning, no need to do much calibration work any more.

- Power saving, 5 times long working time than gimbal without encoder system.

- One IMU.

- Faster response, motor torque increasing instantly, no bug for difficult rotating angle anymore.

- Encoder chip A5048a

iPower GM2804H-100T Hollow Shaft Brushless Gimbal Motor

Introduction:

The GM2804H-100T motor by iPower Motors is the ultimate brushless gimbal motor for GoPro Cameras. This motor is designed for small multi-rotor platforms looking to lift GoPro sized gear – 0.5-1KG/cm Torque. The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.

Specifications:

Model NO.: GM2804H-100T

Weight: 41.5g

Motor Dimensions: Dia 34mm x hgt 15mm

Stator Dimensions: Dia 28mm x hgt 4mm

Copper wire(OD): 0.17mm

Configuration: 12N14P

Resistance: 11.2 ohms

Base center pitch: 16mm 19mm

Pre-wound: with 100 turns, Hollow shaft

Camera range (Torque): 200-400 gram camera

Test Voltage/ Max Voltage: 11.1V/14.8V

Test Current/ Max Current: 0.099A/5A

Test Rotational Speed/Max Rotational Speed: 1637 rpm/2180 rpm

Package included:

- 3 x GM2804H-100T Motor  with AS5048A Encoder & Magnet

- 1 x Pre-flashed encoder firmware Alexmos 32BIT BGC set with alum case

- Connecting cables set

Write a review

Choose a file or drag it here.
Note: HTML is not translated!
    Bad           Good
Captcha

When you order from iflight-rc.com, you will receive a confirmation email. Once your order is shipped, you will be emailed the tracking information for your order's shipment. You can choose your preferred shipping method on the Order Information page during the checkout process.

The total time it takes to receive your order is shown below:

The total delivery time is calculated from the time your order is placed until the time it is delivered to you. Total delivery time is broken down into processing time and shipping time.

Processing time: The time it takes to prepare your item(s) to ship from our warehouse. This includes preparing your items, performing quality checks, and packing for shipment.

Shipping time: The time for your item(s) to tarvel from our warehouse to your destination.

Shipping from your local warehouse is significantly faster. Some charges may apply.

In addition, the transit time depends on where you're located and where your package comes from. If you want to know more information, please contact the customer service. We will settle your problem as soon as possible. Enjoy shopping!

Support