iFlight G40 3 Axis Aerial Gimbal - BLACK EDITION

iFlight G40 3 Axis Aerial Gimbal - BLACK EDITION

OverView

iFlight G40 3 Axis DLSR Aerial Gimbal for SONY 5N, RX-100, BMPCC CameraAttention!! Total eight of the camera including lens and accessories shoul...
$299.99
Product Code: G380023

Product Description

iFlight G40 3 Axis DLSR Aerial Gimbal for SONY 5N, RX-100, BMPCC Camera

Attention!! Total eight of the camera including lens and accessories should be maximum 900g!!

The gimbal is tuned according to 300-600g camera weight including a lens.

If heavier than 600g the gimbal cannot function well and needed to be tuned again!!

Please kindly contact us before placing an order so that we can tune for you!!


Easy Gimbal brushless made by aluminum with vibration dampener on the top alloy and make the gimbal to light, rigid, fast and without gaps.

Features:
•Support Sony NEX5/7, RX-100, BMPCC and another micro -SLR camera
•Support 18-55mm lens
•Ready to Use with 32BIT Alexmos Simple BGC
•Support sensitivity parameter adjustment and software 3D pose display
•Support rocker rate mode and position mode
•Aluminum alloy, half arm frame, sturdy and lightweight
•Adjust the focus with the camera, can be adapted to a different lens
•Active augmentation technology,closed-loop monitoring, and control, more accurate compensation augmentation
•Full adjustable mechanism is designed to allow a perfect balance adjustment to get the best of the best performance


Specification :

Support Receiver:conditional receiver、PPM receiver, DSM2/DSMJ/DSMX receiverSupport Remote Controller Equipment:PPM/PCM/2.3G
Operating Voltage:DC 7.4V~14.8V (Recommand11.1V,3pcs Li-po battery)Operating Current:200mA-2A
Working Environment Temperature:-15℃~65℃Processor:MEGA328P Processor
Sensor:MPU6050 3-axis Gyro、AccelerometerMAX Angular Rate :2000°/SEC
Max Acceleration:16gControl Freqency:1600Hz
Motor Driver Frequency:8/32KHz(Noise power-saving driver/No noise smooth driver)Control accuracy:0.1°
Control Angle Range:-45°~45°(roll), -90°~90°(pitch)Gimbal controller board:iFlight ALEXMOS genuine 32-bit Gimbal controller board(2.43b6)
Motor:iPower GBM4108H-120T motorGimbal+Controller+Shockproof Board Net Weight:564g


Package included:

1x3 axis brushless camera gimbal (ready to use)


Adjust the center of gravity tips:

The camera with the camera fixed on the head nut, before energizing any swinging camera and then released.

The camera can no longer automatically swing fixed on a position it said it had adjusted the focus of the camera, mounted on the circuit board and energized after a good tune focus.


Write a review

Note: HTML is not translated!
    Bad           Good
Captcha
Buy Chromium
Demos 12
Close

Chromium Demos

Check our main demos, layouts, shop and single product pages variants.