iFlight Original BaseCam SimpleBGC 32-bit Extended Gimbal Controller, it is built-in frame IMU, current sensor to measure battery power consumption.
*Built-in Frame IMU
*Current sensor to measure battery power consumption
*CAN-bus to replace I2C for the IMU sensor and other periphery connection
*Dedicated 3x SPI/PWM ports for encoder connection
*Additional I2C port to connect 2nd IMU or encoders
*Built-in sound beeper
*Up to 6s LiPo battery is supported
Specifications:
Size of the board: 50×50 mm
The distance between the mounting holes: 45 mm
The diameter of the mounting holes: 3 mm
Power supply voltage:8-26 V (3s-6s LiPo)
Maximum motor current: 1,5 A
5V output current to power external devices: up to 1 A
3V output current: 150 mA
iPower Motor GBM6208H-150T Brushless Gimbal Motor
The GBM62 series motor by iPower Motors is the ultimate brushless gimbal motor for DSLR / CANON 5D MARKII, MARKIII Cameras. This motor is designed for large scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 4KG/cm Torque. The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
Specifications:
Model NO.: GBM6208H-150T
Weight: 188g
Motor Dimensions: dia 68mm x hgt 24.8mm
Stator Dimensions: dia 62mm x hgt 8mm
Copper wire(OD): 0.25mm
Configuration: 24N22P
Resistance: 11.5 ohms
Base center pitch: 25mm 30mm
Pre-wound: with 150 turns, Hollow shaft
Hollow Shaft Diameter: 12.6mm
Camera range: 950-2300 grams
Test Voltage (Max Voltage): 11.1V (22.2V)
Test Current: 0.086A
Max Current: 10A
Test Rotational Speed (Max): 278 rpm (560 rpm)
Package included:
- 3x iPower GBM6208H-150T Gimbal Motor
- 1 x Alexmos 32BIT Extended BGC set with alum case
- 1 x Connecting cables set
