- Model 1 setup：Reveiver tap -----> Choose “Spektrum / Graupner / JR (TAER1234)”
- Model 2 setup：Reveiver tap -----> Choose “Frsky / Futaba / Hitec (AETR1234)”
The SucceX-D F7 is designed to work seamlessly with DJI’s new HD FPV system.To make things as simple as possible, we have included a connector specifically for the DJI air unit, so installation should be a breeze. In additionally, we add the popular and reliable USB Type-C instead of Micro USB which makes connection easily.
• Universal USB Type C connector instead of micro USB
• Plug-and-Play. No need to solder tiny wires.)
• Supports BLHeli pass-through for easy ESC upgrade and configuration.
• Designed to support DJI Digital FPV.
SucceX-D F7TwinG SPECS：
- MCU：216MHz STM32F722RET6
- Gyro: 2x ICM20689
- Betaflight OSD：YES
- Blackbox: 32MB
- 5 x Uarts
- 8 x Motor outputs
- 8 pin 4in1 ESC port
- 4-pin VTX connector
- Betaflight Firmware：betaflight_4.0.5_STM32F7X2.hex
- CLI config：IFLIGHTF7_TWIN_G.config
- Mounting hole：30.5*30.5mm，φ4mm with Grommets φ3mm
You might like:
- SucceX-D F7 TwinG Flight Controller (HD Version)
The DJI Air Unit is not included in the package.